2. Remove the corresponding wheel (see Introduction).
3. If a protective cap is installed on the wheel hub, remove it using a screwdriver - it must be replaced without fail.
4. The hub nut is tightened with very great force. To keep the hub from turning, it is necessary to fix a special lever on it using wheel bolts (see accompanying illustration).
Note: If necessary, the lever can be made independently.
5. Loosen the hub nut and remove the nut from the drive shaft journal, if necessary, separate the lever from the hub.
6. Installation is carried out in the reverse order of removal. When installing, it is necessary to use only new self-locking hub nuts. Tightening the nut is carried out in 3 steps (see Specifications). If equipped, do not forget to install a new protective cap.
Visitor comments