Note: New hub to trailing arm nuts will be required.
1. Remove the rear brake disc (see Chapter 9).
2. Disconnect the connector (see accompanying illustration) aBS wheel sensor wiring, loosen the 4 mounting nuts and remove the hub assembly with the brake shield.
3. Install the hub assembly and secure it with new nuts. Tighten the nuts to the required torque in 3 stages (see Specifications). When installing the assembly, it must be given the exact position it occupied before removal - to check the position at service stations, a special template HAZET 6690 is used; for individual use, you can cut the template out of thick cardboard.
4. Further installation is carried out in the reverse order of removal. Follow all instructions for installing brake system components given in the relevant sections Chapters 9. After completing the procedure, do not forget to adjust the parking brake.
Visitor comments