Headlight/Front turn signal
1. Remove the front bumper.
2. Turn away 2 top and 1 bottom bolt, get the block headlight, having disconnected a socket. Loosen the screws and remove the bumper trim at the bottom of the headlight (see photo).
3. If necessary, remove by turning it 90° (see photo).
4. Installation is carried out in the reverse order. Check and, if necessary, adjust the beam of headlights in a car service.
Front fog lights
5. Remove the front bumper.
6. Turn away 3 bolts and remove a headlight, having disconnected a socket (see photo).
Side repeater
7. Move the diffuser of the repeater back and remove from the wing.
8. Get a plafond of the repeater and disconnect wires.
9. When assembling, press the back of the diffuser until it clicks into place.
Rear lights
10. The procedure for removing the rear lights is illustrated in the photo.
License plate light (hatchback and sedan)
11. The license plate light on hatchback and sedan models is mounted on top of the rear bumper.
12. Remove the diffuser, press on the right edge of the lamp and pull it out by the left edge. Disconnect the wires (see photo).
License plate lamp (station wagon and Zafira)
13. Turn away screws and get a diffuser of a lantern from a back cover.
Visitor comments