Removing
Loosen the front wheels, raise the front of the car.
Mark with chalk the installation position of the wheels; for this, make a mark on the disk and on the hub.
Remove brake pads.
Loosen the stop screw of the hub.
Slightly tilt the brake disc and remove it from the hub.
On vehicles with light metal rims, remove the trim from the rim.
Installation
In order for both wheels to provide the same braking, both discs must have the same surfaces. Therefore, both disks should be replaced or given for processing.
Insert the brake disc, tighten the locking screw.
In vehicles with light metal rims. Put the lining on the shoulder of the brake disc.
Install brake pads.
Install the front wheels, take into account the labels.
Lower the vehicle, tighten the wheel bolts crosswise to 90 Nm.
Visitor comments