Inclusion
All doors, windows, retractable roof and hood must be closed. Not later than 10 seconds after locking, press the button on the remote control again.
If the ignition is turned on, the driver's door must be opened and closed so that the anti-theft alarm device can be activated.
Switching on without interior control and vehicle tilt
1. Close the trunk and hood.
2. Press the button in front of the interior lamp (with the ignition off), the LED flashes for a maximum of 10 s.
3. Close the doors.
4. Turn on the anti-theft alarm device, the LED is on. Approximately 10 seconds later the device will be activated – without cabin control and vehicle tilt. The LED continues to flash until the device is turned off.
Light-emitting diode
During the first 10 seconds after the anti-theft alarm device is turned on:
- the LED is on, which means control and delay;
- the LED flashes, it means that the door, tailgate, hood are open, or the system is faulty.
If after about 10 seconds after turning on the anti-theft alarm device, the LED flashes, this means that the device is turned on.
If the LED lights up for about 1 s, then its function is disabled.
In the event of a malfunction in the system, contact a workshop for assistance.
System shutdown
Press key (see picture) remote control or turn on the ignition.
If the remote control malfunctions, turn the key in the driver's door lock all the way forward. Turn the key back to the vertical position and remove.
If the alarm goes off when the driver's door is opened, disable the anti-theft alarm by turning the ignition on.
Opening and closing the back door when the anti-theft alarm is on
Unlocking: turn the key all the way to the right - the trunk is unlocked, the interior monitoring and vehicle tilt control devices are deactivated.
Open trunk.
Close the trunk.
Locking: turn the key back to the horizontal or vertical position. After approximately 10 seconds, the interior and vehicle tilt control will be activated again.
Signaling
When the anti-theft alarm device is on, the alarm may sound: audible (beep) and light (alarm signaling by all direction indicators).
The number and duration of signals is limited by law.
The alarm can be turned off by pressing the remote control button or by turning on the ignition. When the button is pressed or the ignition is turned on, the anti-theft alarm device is turned off at the same time.
Visitor comments