Before replacing the lamp, turn off the ignition and the corresponding lighting device.
1. Detach the bumper cover from the side and remove the headlight (see section Removal and installation headlights).
2. Disconnect the three connectors (low and high beam, as well as direction indicators and beam adjustment).
Incandescent lamp connector
Direction indicator
1. Press the turn signal socket towards the reflector, release it by turning it to the left and remove it from the reflector.
2. Remove the old lamp from the socket.
3. Insert a new lamp into the socket.
4. Insert the cartridge into the reflector and secure it by turning it to the right.
5. Connect the connector.
Headlight bulbs (high beam, low beam and parking light)
1. Fold aside both clips and remove the headlight cover.
Releasing the headlight cover
2. To replace the high or low beam bulb, disconnect the connector from the bulb, remove the spring clip of the bulb holder from the retaining tabs and fold back the clip.
Spring clamp lamp holder
3. Remove the incandescent bulb. Insert the new bulb so that the bulb holder fits into the reflector grooves. Hold the bulb only by the holder, not by the bulb. Remove any fingerprints left on the bulb with a clean cloth soaked in alcohol.
4. Fix the spring clip. Connect the lamp connector.
5. To replace the parking light bulb, loosen the socket by turning it to the left and remove it from the reflector. Remove the bulb from the socket and replace it. Secure the socket in the reflector by turning it to the right.
Installing a parking light bulb
6. Place the cover on the headlight and secure it with the clamps.
7. Connect the two connectors until the headlight locking tabs are locked into place.
8. Install the headlight and adjust it (see section Headlight adjustment).
Visitor comments