Clutch Master Cylinder — Removal and Installation (Opel Astra G)

1. Remove the relay panel from the ABS valve block by bending the latches. Remove the panel bracket.

2. Disconnect the fluid supply hose from the cylinder and plug the holes.

3. Disconnect the spring from the clutch pedal, remove the clamp and disconnect the hose from the tube, plug the holes.

4. Remove the trim in the driver's side footwell, unpin and remove the clutch pedal shaft.

5. Inside the passenger compartment, unscrew the 2 bolts. Remove the master cylinder from the engine compartment.

6. Installation is performed in reverse order. Replace the gasket of the nipple on the tube to which the hose is connected near the pedal. When finished, bleed the air from the clutch hydraulic drive.

Original posted on the website: Opelbook.ru