Washer jets
Remove the grille (see chapter 11). Unscrew the two screws and remove the injectors from the grille.
Installation is carried out in the reverse order of removal.
Spray nozzles can be adjusted with a needle by inserting it into the jet and turning it in the desired direction.
Liquid tank
The headlight washer fluid reservoir is located in the rear left corner of the engine compartment.
Disconnect the negative battery terminal.
In the engine compartment, unscrew the filler neck from the top of the tank.
Remove the wheel arch trim (see chapter 11).
Unscrew the three screws securing the reservoir and remove it in such a way as to disconnect the pump connector and the fluid supply hose. Be careful, fluid may leak when disconnecting the hose.
Remove the reservoir from under the wheel arch.
Installation is carried out in the reverse order of removal.
Remove the pump, being careful when doing so, as liquid may leak.
Check the condition of the sealing sleeve between the tank and the pump, if necessary, replace it.
Installation is carried out in the reverse order of removal.
Visitor comments