Electronic control unit
The control unit is located behind the side trim near the right-hand footwell (fig. 12.37, 12.38).
Fig. 12.37. Anti-theft device:
I — electronic control unit; 2 — radio/cassette device sensor; 3 - hood switch; 4 - ignition switch; 5 - LED and backlight; 6 — Rear door/trunk lid switch; 7 - door lock switch; 8 — relay (disconnects the starter); 9 — backlight switch; 10 - sound signal
Disconnect the negative battery terminal.
Remove the side footwell trim panel (see chapter 11).
Remove the two plastic nuts, then remove the control unit from the footwell by disconnecting the plug connector.
Installation is carried out in the reverse order of removal.
Hood open indicator
Disconnect the negative battery terminal.
Using a screwdriver, carefully release the clamp and remove the indicator from the bracket located on the head of the suspension strut (fig. 12.39).
Disconnect the plug connector and remove the device.
Installation is carried out in the reverse order of removal.
Sound signal
The horn is located on the left side of the front fender inner panel next to the battery (fig. 12.40).
Disconnect the negative battery terminal, then disconnect the wire from the anti-theft device horn.
Loosen the nut and remove the horn from the bracket. Or, loosen the mounting bolt and remove the bracket together with the horn.
Installation is carried out in the reverse order of removal.
Visitor comments