The hood, trunk lid, doors and front fenders are bolted together and can therefore be easily removed and replaced. When installing body parts, it is imperative to observe the necessary clearances, otherwise, for example, the door may knock, or increased air flow noises will be observed during movement.
The gap must always run parallel, which means that the distance between the body parts must be the same along the entire length of the gap. Permissible deviations should not exceed 1 mm.
Front and rear windows glued. They must be replaced by a specialist workshop.
Attention! If work is to be carried out on the electrical system, it is imperative to disconnect the wire terminal «masses» (-) from the negative pole of the battery. Work on the electrical system is considered to be the normal disconnection of the electrical wire or plug.
Attention! Numerous trim elements and linings are attached using clips and clips. Damaged fasteners and clamps must always be replaced with new ones.
Visitor comments