Examination
Remove air filter.
Remove the carburetor cover.
Remove seal, filling part, float with needle.
The clamp with the needle must be correctly hung on the arc.
Gap A between the clamp and the bulge should be 0.1-0.3 mm. Foldable adjustable.
Install the float with needle and float shaft into the float chamber.
Slightly press the arc of the float, fig. higher.
Attention! The float shaft must not protrude.
Measure the distance between the body plane and the float. The set value is 7.5-8.5 mm.
Adjustable by bending the tabs (arrows).
Install the carburetor cover.
Install filter.
Visitor comments