Removing
Remove air filter.
Disconnect the start cable.
Mark and remove fuel lines.
Remove the vacuum hose for the vacuum regulator.
Attention! Do not remove the hose from the vacuum regulator.
Remove the four Phillips screws from the carburetor cover.
Unscrew the two nuts and remove the carburetor cover.
Installation
Install a new cover gasket.
Install cover and screw loosely with two nuts and washers.
Tighten the 4 Phillips screws by hand.
Finally tighten the nuts and screws.
Put on the vacuum hose.
Put on the fuel lines.
Connect and adjust the start cable.
Check and set starter flap clearance.
Install the air filter.
Visitor comments