Removal and installation rear springs (sedan) (Opel Kadett D)

The instructions apply to the sedan only.

Removal

Even if one spring is faulty, both springs should be replaced.

Raise the car.

Note: On vehicles with adjustable ride height, release air from the shock absorber through the valve. Remove and install springs sequentially.

Use a hydraulic lift to raise the bracket on the rear suspension.

Unscrew the shock absorber and remove it from the holder on the bracket. If necessary, use a pry bar for this.



Lower the hydraulic lift.



Remove the spring from its mounting points on the body and suspension. At the same time, press the rear suspension downwards with the crowbar.

Remove the lower damping ring from the spring.



Press the upper damping ring out of the spring and check for wear, replace if necessary.

Installation

Insert the upper damping ring into the spring. To simplify installation of the spring, cover the damping ring with a thin layer of glue (OPEL No.1504851/9293725).

Insert the lower damping ring.



Insert the spring into place. Make sure that the spring is positioned correctly (arrow).

When installing the spring, press the suspension with the pry bar downwards and insert the spring.

Material copied from this portal: www.opelbook.ru

Install the shock absorber, see paragraph 13.1.