Removal
Manual transmission
1. Remove the gearbox and clutch.
2. Lock the flywheel and mark its correct installation position.
3. Remove the bolts and flywheel.
Automatic transmission
1. Remove the gearbox.
2. Lock the drive disc and loosen its bolts.
Text copied from this portal: OpelBook
3. Completely unscrew the bolts and remove the drive disc.
Examination
Check the flywheel for wear and damage. If any is found, contact a specialist.
Installation
Manual transmission
1. Manual transmission
2. Clean the mating surfaces of the flywheel and crankshaft. Clean the bolt threads.
3. Install the flywheel, insert and tighten the bolts to the required torque (drawing on the left), and then additionally to the required angle (drawing on the right) (cm. subsection 3.1.1)
4. Install the clutch and gearbox.
Automatic transmission
1. Clean the mating surfaces of the drive disk and crankshaft. Clean the bolt threads.
2. Install the drive disc and tighten the bolts.
Visitor comments