Examination
1. Raise and secure the front of the vehicle.
2. Inspect rubber mounts for wear and damage and replace if necessary.
3. Check that the support bolts are firmly tightened.
4. Check if the bearings themselves are worn out.
Replacement
Left and right engine mounts
1. Raise and secure the front of the vehicle.
2. Place a jack under the engine and transmission, or secure the engine on a hoist.
3. Remove the nuts securing the mounts to the cylinder block bracket and body. Remove supports. Remove the bracket if necessary.
4. Inspect the bearings for wear and damage and replace if necessary.
5. Install the supports in reverse order.
Rear Gearbox Mount
1. Raise and secure the front of the vehicle.
2. Install a jack under the gearbox.
3. Unscrew the bolts securing the cross member of the rear gearbox support to the body. Unscrew the nuts securing the support to the cross member and remove the cross member.
4. Unscrew bolts and remove a support.
5. Inspect the support for wear and damage and replace if necessary.
6. Install the support in reverse order.
Visitor comments