Removing
Manual Transmission
1. Remove the gearbox and clutch.
2. Stop the flywheel and mark its correct installation location.
3. Unscrew the bolts and remove the flywheel.
Automatic transmission
1. Remove the gearbox.
2. Lock the drive disc and loosen its bolts.
3. Completely unscrew the bolts and remove the drive disc.
Examination
Check the flywheel for wear and damage. If you find any, contact a specialist.
Installation
Manual Transmission
1. Clean the mating surfaces of the flywheel and crankshaft. Clean the threads of the bolts.
2. Install flywheel, insert and tighten bolts (drawing on the left), tighten the bolts further to the required angle (drawing on the right) (see subsection 3.2.1)
3. Install the clutch and gearbox.
Automatic transmission
1. Clean the mating surfaces of the drive plate and crankshaft. Clean the threads of the bolts.
2. Install drive disc and tighten bolts.
Visitor comments