Removing
1. Disconnect the ventilation hoses from the camshaft cover.
2. Unscrew the bolts and remove the spark plug cover (drawing on the left), disconnect the wires from the candles (drawing on the right).
3. Loosen the nut and remove the harness holder at the top of the timing belt cover.
4. Disconnect the wire from the camshaft sensor and from the camshaft cover.
5. Remove the camshaft cover bolts.
6. Remove cover and gaskets, replace gaskets if necessary.
Installation
1. Carefully inspect and clean the mating surfaces of the cover and cylinder head. Install gaskets.
2. Apply sealant N15 03 295 to the surface of the cylinder head around the front camshaft bearing caps and into the semi-circular cutouts at the rear of the head.
3. Install the cover, insert and tighten the bolts.
4. Install the remaining parts.
Visitor comments