Removing
Remove front wheel. Disconnect the brake hose from the slave cylinder and plug the hose opening to prevent leakage of brake fluid.
Depending on the version, disconnect the wires from the brake pad wear sensor.
Unscrew the bolts securing the guide pads to the steering knuckle and remove the caliper assembly with the guide and brake pads.
Installation
Install the caliper assembly and tighten the bolts securing the guide pads to the steering knuckle.
Connect the brake hose with new o-rings.
Depending on the modification, connect the wires to the brake pad wear sensor.
Install the front wheel, bleed the hydraulic brake system and make sure there is no brake fluid leakage.
Visitor comments