Engines 1.6 and 1.8 l
1. Remove the engine wiring harness guide (1) from the cylinder head.
2. Disconnect the ignition coil connector (2).
3. Remove the ignition coil cover in the direction of the arrow on the cover.
Note: Follow the arrow on the lid.
4. Unscrew the two ignition coil bolts.
5. Install the EN-6009 device (1).
6. Remove the ignition coils (2).
7. Remove the EN-6009 tool (1).
8. Installation is carried out in the reverse order of removal.
Note: Tightening torque of ignition coil bolts: 8 Nm.
Petrol engines 2.0 l
To replace the ignition coils, you need to remove the decorative engine cover and, referring to the figure, disconnect the corresponding electrical connector and remove the ignition coil.
1. Ignition coil mounting bolt (tightening torque 10 Nm).
2. Ignition coil.
2.8L petrol engine
To replace the ignition coils, you need to remove the upper intake manifold and, using the illustrations as a guide, disconnect the corresponding electrical connector and remove the ignition coil.
Left bank of engine cylinders:
1. Ignition coil mounting bolts (tightening torque: 10 Nm).
2. Ignition coils.
Right bank of engine cylinders:
1. Ignition coil mounting bolts (tightening torque: 10 Nm).
2. Ignition coils.
Visitor comments