2. Remove the front wheel from the vehicle.
3. Support the steering knuckle with a suitable jack.
4. Using a puller CH 43631, disconnect the ball joint from the steering knuckle.
5. Loosen the nut (1) steering knuckle mounting.
Note.
Nut tightening torque (1):
- First stage: 50 Nm.
- Second stage: another 30°.
6. Remove bolt (2) steering knuckle mounting. Do not reuse the bolt, always replace it with a new one.
7. Loosen the nut (3) lower control arm front suspension. Do not reuse the nut, always replace it with a new one.
Note.
Torque:
- First stage: 100 nm.
- Second stage: another 75°.
8. Remove bolt (4) lower control arm front suspension. Do not reuse the bolt, always replace it with a new one.
9. Remove the two rear nuts (5) lower control arm front suspension.
Note.
Torque:
- First stage: 100 Nm.
- Second stage: another 75°.
10. Remove the two rear bolts (6) lower control arm front suspension.
11. Remove the lower front suspension arm (7).
12. Installation is made in an order, the return to removal.
Attention. This component is equipped with fasteners that are tightened to the yield point. When installing a component, you must use new fasteners. Failure to do so may result in vehicle damage.
13. After installing the lower arm of the front suspension, it is necessary to check and adjust the wheel alignment angles.
Visitor comments