Removing
1. Raise and secure the vehicle.
2. Remove the wheel from the car.
3. Remove and fix the brake caliper on the car body, then remove the brake disc.
4. Unscrew the fastening bolts (1) and remove wheel hub with bearing (2).
Suspension G.N.A
Suspension GNB
Note. If necessary, using the CH-43661 puller, remove the stud from the wheel hub. Replace wheel studs with new ones after each removal.
Installation
1. Insert a new wheel stud into the hub.
2. Install some washers (1) on the wheel stud, then screw on the nut (2) flat side to the washers.
3. Tighten the nut (2) so that the head of the wheel stud is fully inserted into the hub, being flush with its rear surface.
4. Remove the nut (2) with washers and install the remaining wheel studs in the same way.
5. Install the hub with the bearing.
6. Install the brake disc with brake caliper.
7. Install the wheel on the car.
8. Lower the car.
Visitor comments