Removing
1. If equipped, remove the crankcase protection.
2. Remove the drain plug and drain the engine oil (see chapter Current service).
3. Sensor (if installed) is located in front of the engine crankcase, - disconnect the electrical wiring from it.
4. Unscrew the sensor from the pallet.
Installation
1. Install a new O-ring and lightly lubricate the sensor threads with locking compound.
2. Screw the sensor into the pan - try not to break the thread.
3. Attach electrical wiring.
4. Install the crankcase protection.
5. Finally, fill the engine with oil (see chapter Current service).
Visitor comments