Attention: Pay attention to the right-hand and left-hand threads on the steering rods.
Removing
Unscrew the bolts of the clamping collar of the thrust.
Remove the lockwasher wedge from the plate.
Unscrew the rod from the steering gear.
Loosen the opposite link bolt.
Unscrew the rod from the adjusting bolt.
Installation
Screw the rod onto the adjusting bolt.
Attention: When screwing in, make sure that the bolt enters to the previous depth. Insufficient depth endangers the safety of the vehicle.
Take into account the right and left version of the drawbar. Screw in the clamp bolt from below.
Screw both rods to the steering box with 50 Nm.
Secure both bolts with lock washers.
Attention: Always use a new clip to fasten washers.
Adjust wheel alignment see point 15.1.
Attention: When replacing both rods, take into account the right-hand or left-hand version. The clamp bolt is always screwed in from below.
Visitor comments