Removing
1. Remove the corresponding wheel.
2. Remove the brake caliper.
3. Remove the mounting clip.
4. Remove the hydraulic hose from the bracket on the strut.
5. Remove the ABS sensor.
6. Unscrew the fixing nut and disconnect the anti-roll bar.
7. Mark the installation position of the stub axle.
8. Loosen the fixing screws.
9. Remove the mounting bolts and pin.
10. Remove the cap.
11. Loosen the top fixing nut.
12. Remove the disk.
13. Hold the shock absorber piston rod so that it does not rotate.
14. Remove the stand from the vehicle.
Repair
1. Install the compressors on the spring.
2. Attach the shock absorber.
3. Remove the bearing.
4. Remove the puck.
5. Remove the bearing.
6. Remove the puck.
7. Remove the upper spring seat, upper damper, stop and casing.
8. Remove the spring.
9. Clean all elements and inspect them for wear or damage. Replace failed elements.
10. Check shock absorber operation.
11. The assembly of the rack elements is carried out in the reverse order.
12. Install the rubber damper on the lower spring seat.
13. Install the spring on the lower seat.
14. Install the rubber damper on the top spring seat.
Installation
Installation is carried out in the reverse order of removal.
Visitor comments