2. Raise and align the transfer case to the correct position relative to the gearbox.
3. Install the transfer case. Tighten the bolts in the sequence shown in the figure to a torque of 110 Nm.
4. Carefully to avoid damage, install the support bracket between the transfer case and the engine in three steps.
5. Tighten the bolts (1) fixing the support bracket with a torque of 5 Nm.
6. Tighten the bolts (2) fastening the support bracket to the engine with the specified tightening torque.
Note.
Torque:
- LBW/A28NET: 22 Nm.
- LDK/A20NHT and LBY/A20DTR: 60 Nm.
7. Tighten the bolts (1) support bracket with a torque of 60 Nm.
8. If equipped, install bleed hose.
9. Install the gearbox rear mounting bracket.
10. Install the subframe.
11. Install the front fender liner.
12. Install the right drive shaft.
13. Install the cardan shaft.
14. Pour gear oil into the gearbox.
Visitor comments