Replacing the wheel angle position sensor (Opel Insignia A)

1. Remove the contact disk of the passive safety system from the steering column.

2. Squeeze the clips on the contact disk of the passive safety system and remove the steering wheel angle sensor (1).

2. Squeeze the clips on the contact disk of the passive safety system and remove the steering wheel…

3. Installation is performed in the reverse order of removal. After installation, it is necessary to perform the steering wheel angle sensor calibration procedure.

[Source is on the website: www.OPELBOOK.ru]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Zinoviev Kirill

Share information:

Opel Insignia A: Brake system

Replacing the yaw rate sensor
Replacing the rear wheel speed sensors
Replacing the front wheel speed sensors
Replacing the electronic brake control unit
Calibrating the Yaw Rate Sensor
Calibration of the brake pressure modulator pressure sensor

Specification
Service data
Special tools and accessories
Operating materials
Tightening torques for threaded connections
Checking the level and topping up the power steering fluid

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet