Gearbox indicator
The display shows the position of the automatic transmission selector lever or the selected gear and operating mode on the Easytronic transmission.
Tachometer
Induces the number of engine revolutions.
Warning box (red zone): Indicates that the maximum permissible RPM has been exceeded.
Speedometer
Induces vehicle speed.
Odometer
Induces the number of kilometers driven.
With the ignition off, after briefly pressing the setting button (see picture) for about 15 kilometers the distance is shown.
Trip counter
The counter is set to zero by pressing the setting button with the ignition on and the daily mileage display active.
Cars with a clock in the odometer
To reset the counter, keep the setting button pressed for about 2 seconds with the ignition on and the daily mileage display active.
To switch between daily mileage and time display, briefly press the setting button.
Time indication on the odometer
To switch between daily mileage and time display, briefly press the setting button.
The brightness of the display is adjusted when the light is on with the right knurled knob 0 under the light switch.
Time setting
When displaying the time, use the setting button on the device: keep it pressed for about 2 s, while the hour display flashes. Press briefly, set the clock, press for approx. 2 s. After that, the minutes display flashes, press briefly and set the minutes, press for about 2 seconds, then the clock starts.
Coolant temperature display
For physical reasons, the coolant temperature is only displayed if the coolant level is sufficient.
During engine operation, the system is under high pressure. Therefore, the temperature may briefly rise above 100°C.
Fuel gauge
It is strictly forbidden to drive to an empty tank.
Due to the presence of fuel residues in the tank, the amount of fuel filled may be less than the specified nominal capacity of the fuel tank.
Visitor comments