System type | |
All models | The cooling system is under pressure and includes cross flow radiator, belt driven water pump actuator, bypass thermostat and expansion tank. Main Managed fan with one or two additional fans. |
Thermostat | |
Starts to open up |
92°
|
Fully open |
107°
|
Coolant | |
Type |
See subsection 1.14
|
Volume |
See subsection 2.1.1
|
Tightening torques, Nm
All models | |
Air conditioner compressor: | |
- front bracket bolts |
35
|
- rear bracket bolts |
20
|
Air conditioner refrigerant pipe connections: | |
- bolts securing the tube to the flange in the separating partition of the engine compartment |
20
|
- bolts securing the tube to the compressor (M10) |
40
|
- bolts securing the tube to the condensate chamber |
20
|
- bolts securing the tube to the control valve |
9
|
– bolts securing the tube to the pulsation damper |
27
|
- bolts securing the tube to the expansion tank air conditioner |
20
|
- bolts securing the air conditioner switch with three provisions |
7
|
coolant pump |
25
|
Steering column strut bolts: | |
- bolts securing the spacer to the steering column |
22
|
- bolts securing the spacer to the floor |
22
|
Four cylinder models: | |
- bolts securing the coolant pipe to the thermostat cover |
8
|
– temperature sensor bolts |
11
|
– cover of a casing of the thermostat |
15
|
Six-cylinder models: | |
- bolts securing the coolant pipe to the cylinder head |
30
|
- bolts securing the inlet pipe to the cylinder block |
20
|
- the bolts holding the inlet to the outlet collector |
6
|
- bolts securing the coolant pipe to the cylinder head |
25
|
– bolts of the block of the temperature sensor |
18
|
– bolts of a cover of a casing of the thermostat |
20
|
Visitor comments