Auxiliary fan
1. Remove the grille as described in Chapter 11.
2. Loosen the horn mounting bolt and slide it to the side.
3. Disconnect the front mount and fan bracket.
4. Disconnect the multi-pin plug, then, being careful, remove the fan so as not to damage the condenser fins.
5. Assembly is carried out in reverse order.
Compressor (with attached pipes)
6. From the compressor, disconnect the wire contacts of the safety magnetic clutch switch (at high pressure) and auxiliary fan switch.
7. Loosen the adjusting and pivot bolts.
8. Unscrew the outer adjusting locknut to loosen the drive belt, then remove the drive belt from the pulley.
9. Remove the pivot and adjusting bolts and slide the compressor to one side.
10. Assembly is carried out in the reverse order, while adjusting the drive belt is carried out as described in Chapter 13 of Section 2.
Visitor comments