Removing
Unscrew the brake fluid reservoir cap and replace it with a sealed cap.
Loosen the tension spring bracket mounting bolts and disconnect the tension spring.
Disconnect the brake pipes from the pressure regulator, having previously noted their location, and plug their holes with plugs.
Remove the regulator and unscrew the stamped protective cap.
Installation
Screw the protective cap onto the new pressure regulator and install it in the reverse order of removal.
Remove the seal from the brake fluid reservoir and screw on the stock cap.
Bleed the hydraulic brake system and make sure the connections are tight.
Check the operation of the pressure regulator.
Visitor comments