Removing
1. Remove the oil filter cap (1).
Note. Do not use an open end wrench on the hex of the oil filter cap.
2. Remove seal (2).
3. Remove the filter element (3).
Installation
1. Lubricate the threads of the oil filter cap (2) and NEW o-ring (1) clean engine oil.
Attention. Before installing the oil filter cover, grease must be applied to its threads. Failure to do so will make it difficult to remove the cover later and cause possible damage to the oil filter.
2. Install a new filter element.
3. Fit the oil filter cover with seal and tighten to 25 Nm.
Attention. The tightening torque of the oil filter cap must be adhered to. Failure to do so will make it difficult to remove the cover later and cause possible damage to the oil filter.
Note. Do not use an open end wrench on the hex of the oil filter cap.
Visitor comments