Removing
1. Remove the dipstick with guide tube.
2. Remove the air conditioning compressor.
3. Remove the A/C compressor bracket.
4. Remove the catalytic converter bracket.
5. Drain engine oil.
6. To turn away bolts of fastening of the oil pallet.
7. Pry off the oil pan (1) and remove from the engine.
Installation
Note.
- The underside of the crankcase must be clean before sealant is applied.
- Installing and adjusting the position of the oil pan on the engine must be carried out within twenty minutes from the moment the sealant is applied.
- The final tightening of the oil pan bolts must be done within one hour of applying the sealant.
1. Apply a bead of sealant (1) with a diameter of 2.25 mm on the flange surfaces around the perimeter of the installation of the oil pan on the cylinder block, as well as around the opening of the oil intake channel.
2. Install oil pan (1).
3. Install the oil pan bolts and tighten in the sequence shown in the figure to a torque of 25 Nm.
Visitor comments