Contents: Drive cable ⬇ Drive/electronic control unit ⬇ Clutch pedal switch ⬇ Steering column switches ⬇
Drive cable
Removal
1. Disconnect the accelerator cable from the throttle lever.
2. Remove the retaining ring and disconnect the cruise control cable from the throttle lever.
3. Remove the cable guide from the mounting bracket.
4. Disconnect the cable from the electronic control unit of the system and remove it.
[Original source is on the website: www.opelbook.ru]
Installation
Installation is carried out in the reverse order of removal.
Drive/electronic control unit
Removal
1. Disconnect the cable from the electronic control unit.
2. Disconnect the connection connector, unscrew the fastening nuts and remove the module.
Installation
Installation is carried out in the reverse order of removal.
Clutch pedal switch
Removal
1. Remove the trim panel and air ducts under the instrument panel.
2. Remove the drive pin and bushing from the switch.
3. Press the latches and remove the switch from the mounting bracket. Disconnect the connection connector.
Installation
Installation is carried out in the reverse order of removal.
Steering column switches
See. subsection 14.4.
Visitor comments