Removing
1. Remove the wiper arms.
2. Remove the seal from the rear wall of the engine compartment.
3. Loosen the fixing screws of the drainage panel.
4. Lift the seal, remove the latches and remove the panel.
5. Remove the drainage panel.
6. Loosen the mounting screws and remove the hose clamp.
7. Disconnect the motor connector.
8. Unscrew the fixing bolts of the connecting mechanism and the motor on the left and right sides.
9. Loosen the mounting bolts in the center and remove the motor and coupling mechanism.
10. Remove the motor from the coupling mechanism, if necessary.
Installation
Installation is carried out in the reverse order of removal. The latch on the left side should fit into the corresponding hole (indicated by an arrow) on the bracket.
Visitor comments