2. Fully release the parking brake lever.
3. Raise and secure the car.
4. Carefully slide the transmission tunnel insulator down just enough to access the drive cable balancer.
5. Rotate the end of the front parking brake cable (1), to unhook it from the balancer.
6. Remove 4 nuts (2) parking brake.
Note. Tightening torque: 10 Nm.
7. Disconnect the electrical connector from the parking brake indicator switch.
8. Remove the parking brake lever (3) assembled.
9. Installation is made in an order, the return to removal.
10. After installation, adjust the parking brake cable tension.
Visitor comments