Main Astra Corsa Insignia Kadett Omega Vectra Zafira Others Articles

Insignia A (2008-2017)

Replacing the Parking Brake Indicator Switch (Opel Insignia A)

1. Remove the front floor console.

2. Loosen the screw (1) securing the parking brake indicator switch.

Note: Tightening torque: 2.5 Nm.

Note: Tightening torque: 2.5 Nm.

3. Remove the parking brake indicator switch (2).

4. Installation is carried out in the reverse order of removal.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Zinoviev Kirill

Share information:

Previous articles

Opel Insignia A: Brake system

Next articles

Replacing the parking brake lever handle
Replacing the parking brake lever
Adjusting the parking brake
Regrinding of front brake discs
Checking the technical condition of the rear brake discs
Replacing rear brake discs

Replacing the Parking Brake Switch
Replacing the parking brake cable
Electric parking brake (J71)
Electronic Parking Brake System Control Unit
Centering the steering wheel angle sensor
Calibration of the brake pressure modulator pressure sensor

See similar ones from other Opel car manuals:
▶ Replacing the Parking Brake Indicator Lamp Switch Opel Astra J (2009-2015, petrol)
▶ Removal and installation the parking brake indicator light… Opel Corsa C (2000-2006, petrol)
▶ Replacing the parking brake pads Opel Frontera A (1991-1998, petrol)
▶ Technical characteristics of the parking brake system Opel Kadett E (1984-1995)
▶ Parking brake lever and cables — removal and installation Opel Omega B2 (1999-2003)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

We want your visit to be comfortable 🤝! We use cookies 🍪 to make that happen.