Note: The work execution is shown on the example of the operation with the left glass, replacement of the right glass is performed similarly.
Sequence of execution
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the interior light (see "Interior and luggage compartment lighting lamps - removal, replacement of lamps and installation").
3. Remove the luggage compartment shelf.
4. Using a thin slotted screwdriver, remove the two fasteners...
Text copied from a web portal Opelbook.ru
...and remove the ceiling handle.
5. Overcoming the resistance of the clamps, remove the decorative frame.
6. We sink inside...
...and remove the ceiling handle holders.
7. We install the handle back as an assembly (therefore, it is necessary to immediately install the holders in the decorative frame)...
...and we carry out further assembly of the handle in the reverse order.
8. Overcome the resistance of the holders and remove the side panel trim by pulling it towards you.
9. Remove the plug in the luggage compartment.
10. Using a TORX T25 key, unscrew the two rear...
...and two front bolts securing the luggage compartment shelf holder.
11. Remove the holder by disengaging its three fasteners from the rear roof pillar trim.
12. Overcome the resistance of the holders and remove the middle pillar trim by pulling it towards you.
13. In the same way, lower the rear pillar trim.
14. Using a 10 mm socket wrench, unscrew the ten glass mounting nuts.
15. Remove the holders and the glass itself from the three lower glass mounting pins.
16. Install the parts in the reverse order. Before installing the side panel trim, check the condition of its holders.
Broken or damaged holders must be replaced.
Visitor comments