Note: The operation is shown using the example of replacing the left wing. Replacing the right wing is performed similarly.
Sequence of execution
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Remove the mudguard (see "Front fender liner - removal and installation").
3. Using a 10 mm wrench, unscrew the lower bolt of the rear wing mount.
(Information taken from the website OPELBOOK.ru)
4. At the rear of the arch, using a 10 mm socket wrench with an extension, unscrew the middle bolt of the rear wing mount.
5. Open the front door and use a 10 mm socket wrench with an extension to unscrew the upper bolt of the rear wing mount.
6. Move the side part of the bumper cover down and use a 10 mm socket wrench to unscrew the two bolts of the front wing mount.
Recommendation: To make the operation easier, it is better to completely remove the front bumper cover (see "Front bumper - replacement").
7. Pull up and remove the rubber hood buffer.
8. Using a 10 mm wrench, unscrew the three bolts of the upper wing mount.
9. Carefully, trying not to scratch the paint, remove the wing from the car.
10. Install the parts in reverse order.
Visitor comments