Replacing the power steering pressure pipe/hose (six-cylinder engine) (Opel Insignia A)

1. Remove the fuel injector cover.

2. Place a drip tray under the vehicle to collect the fluid.

3. Remove as much working fluid as possible from the power steering expansion tank.

4. Remove the front wheels from the vehicle.

5. Remove the front bumper.

6. Unscrew the hollow bolt (1) of the power steering pressure line connector.

Note.

• When installing, use new sealing rings soaked in power steering fluid.
• Tightening torque of hollow bolt (1): 37.5 Nm.

7. Remove the four clamps (2) of the power steering pressure line.

8. Loosen the bolt (3) of the power steering pressure line bracket.

Note: Tightening torque: 9 Nm.

9. Remove the power steering pressure pipe/hose (4).

10. Installation is carried out in the reverse order of removal, taking into account the following:

• Install new sealing rings, after wetting them with power steering fluid.
• Fill the power steering reservoir with working fluid and bleed the system.
• Remove excess power steering fluid from the vehicle.