Contents: Poor glass cleaning quality.…⬇ The remaining water in the cleaning…⬇ The brush works one-sidedly. It…⬇ There are still some uncleaned…⬇
Poor glass cleaning quality. Smudges, smears
The rubber band is dirty
- Clean the rubber band with a hard nylon brush and detergent or alcohol
Fringe on the working surface of the rubber belt. The belt is torn or worn out
- Replace the rubber band
Aging rubber band. Cracked surface
- Replace the rubber band
The remaining water in the cleaning zone is collected into beads
The glass is oily or contaminated with polish
Article posted on a web portal opelbook.ru
- Clean the glass with a clean cloth and silicone-based grease and oil stain remover
The brush works one-sidedly. It cleans one half of the cleaning zone well, and the other half poorly. The brush vibrates during operation
Deformation of the rubber band. The working surface of the band does not turn to the other edge.
- Install a new rubber seal
The wiper arm is displaced. The wiper blade does not adhere to the glass
- Carefully adjust the position of the brush lever
There are still some uncleaned places left
The rubber band has come out of the mount
- Carefully feed the tape into the holder
The rubber band does not fit evenly to the glass because the holders are bent
- Replace the rubber band. This fault usually appears when the replacement brush is installed improperly
Weak lever pressing force
- Lubricate the lever pivots and springs or install a new lever
Visitor comments