Door wire
Removal and installation
1. Remove the corresponding door lock.
2. Loosen the fixing screws (indicated by arrows).
3. Disconnect the rod (indicated by arrows) and remove the drive.
4. Installation is carried out in the reverse order of removal.
Control block
Removing
1. Remove the trim panel on the right side under the instrument panel.
2. Disconnect the block connector.
3. Unscrew the fixing nuts and remove the block.
Installation
Installation is carried out in the reverse order of removal.
Trunk lid lock drive
Removing
1. Remove the cover trim panel.
2. Disconnect the linkage from the drive.
3. Disconnect the connection connector, unscrew the fixing bolts.
4. Remove the drive.
Installation
Installation is carried out in the reverse order of removal.
Rear door lock drive
Removing
1. Remove the door trim panel.
2. Disconnect the rod from the lock.
3. Loosen the fixing screws.
4. Disconnect the connector and remove the drive.
Installation
Installation is carried out in the reverse order of removal.
Fuel tank damper lock actuator
Removing
1. Remove the trim panel on the right side of the trunk.
2. Disconnect the drive connector.
3. Loosen the two fixing screws.
4. Remove the drive and mounting bracket.
Installation
1. Installation is carried out in the reverse order of removal.
2. Check that the rod passes through the bushing in the body.
3. Check that the rod is connected to the damper stop plate.
Visitor comments