Contents: Glass ⬇ Internal visor ⬇ Air visor ⬇ Upper hatch drive motor, drive…⬇ Top hatch and connecting wires ⬇
Glass
Removal
1. Remove the sunroof trim panels.
2. Mark the position of the side screws.
3. Unscrew the screws and remove the glass.
Installation
Installation is carried out in the reverse order of removal.
Internal visor
Removal
1. Remove the top hatch glass.
2. Loosen the mounting screws and remove the water drain panel.
3. Remove the guides and visor.
Installation
Installation is carried out in the reverse order of removal.
Air visor
Removal
Loosen the mounting screws of the visor lifting mechanism, set the visor vertically and remove it.
Installation
Installation is carried out in the reverse order of removal.
Upper hatch drive motor, drive mechanism and switch block
Removal
1. Remove the switch block trim panel.
2. Remove the switch handle.
3. Remove the diffuser and the lamp.
4. Disconnect the connection connector.
5. Remove the switch.
6. Remove the seal.
7. Loosen the mounting screws.
8. Remove the console.
9. Loosen the mounting screws, disconnect the connection connector and remove the engine.
Installation
Installation is carried out in the reverse order of removal.
Adjustment
To adjust the sunroof drive, completely close, open and close the sunroof.
Top hatch and connecting wires
Removal and installation
To remove and install the top hatch, you must contact a specialist.
Opening the top hatch
If necessary, the top hatch can be opened manually.
Visitor comments