Comment. The performance of the work is shown on the right block headlight. Replacing the left headlight bulbs is performed in the same way.
Warning! Do not touch the bulbs of halogen lamps with your fingers. Work in clean cotton gloves without rubber coating. Fat fingerprints remaining on the lamp bulb will shorten its service life several times. After accidentally touching the lamp bulb with your fingers, wipe the bulb with a clean cloth dampened with alcohol.
High Beam Bulb Replacement
1. We prepare the car for work (see «Preparing the car for maintenance and repair»).
2. Remove the air filter (see «Air filter - removal and installation»).
3. Disconnect the wiring harness from the lamp socket.
4. Turn the lamp counterclockwise and remove the lamp from the headlight.
5. Install a new lamp in reverse order.
Replacing the Low Beam Bulb
1. Disconnect the wiring harness block from the dipped beam lamp socket.
2. Remove the cartridge from the headlight housing.
3. Using a thin slotted screwdriver, remove the lamp from the cartridge.
4. Install a new lamp in reverse order.
Replacing the parking light bulb
1. Turn the side light bulb holder counterclockwise and remove the bulb holder assembly with the lamp from the hole in the headlight housing.
2. Remove the lamp from the cartridge.
3. Install the parts in reverse order.
Turn signal lamp replacement
1. Turn the lamp socket counterclockwise and remove the socket together with the lamp from the headlight housing.
2. We slightly sink the lamp into the cartridge and, turning it counterclockwise, remove it from the cartridge.
3. Install the parts in reverse order.
Visitor comments