- car stand;
- jack;
- anti-recoil stops.
Execution sequence
1. We prepare the car for work (see «Preparing the car for maintenance and repair»).
2. Remove the front wheel (see «Wheel - replacement»).
3. We press out the ball joint pin from the steering knuckle (see «Ball joint - replacement»).
4. With two 18 mm keys, we unscrew the bolt) front attachment of the lever to the subframe.
5. Similarly, we turn off the bolt of the rear mounting of the lever to the subframe.
6. Remove the lever from the car.
Comment. Since the levers are supplied in spare parts assembled with silent blocks and a ball joint, further disassembly is not required.
7. Install a new lever and the bolts are fastened» lever to the subframe without tightening them.
8. Insert the ball joint pin into the steering knuckle and tighten its fastening nut to the prescribed torque (see «Reference data»).
9. We lower the car to the ground and tighten the prescribed moments, first the front and then the rear bolts securing the lever to the subframe (see «Reference data»).
10. Next, install the parts in reverse order.
Visitor comments