The lantern is made on LEDs and is a non-separable structure, therefore, in the event of a malfunction, it must be replaced as an assembly.
Execution sequence
1. We prepare the car for work (see «Preparing the car for maintenance and repair»).
2. Disconnect the lining of the left and right pillars of the tailgate at the place where they adjoin the lining of the additional brake signal. To do this, it is better to use a special device, placing a cloth under it, so as not to damage the paintwork.
3. Using a thin slotted screwdriver, disconnect the wiring harness block from the lining of the left rack.
4. Using the TORX T20 key, we unscrew the two screws securing the additional brake light and remove it.
5. Disconnect the trim from the lantern, alternately disengaging the four holders from the trim.
6. Install an additional brake light in reverse order.
Visitor comments