1. Dipped beam
2. high beam
1. Remove the headlight cover
2. Disconnect the connector from the lamp base, remove the lamp retainer from the clip and rotate it outwards.
3. Push the lamp down on the holder and remove it from the reflector housing.
4. Detach the holder from the lamp base.
Xenon headlight system
1. Dipped beam
2. high beam
1. Push the lamp down on the holder and remove it from the reflector housing.
2. Detach the holder from the lamp base.
Parking lamp
Front turn signal
Fog lights
1. Loosen the screws on the panel next to the fog lights using a screwdriver and remove the panel.
2. Remove the screw on the outside of the fog lamp, rotate the headlight to the side and remove it.
3. Remove the protective cover from the back by turning it.
4. Detach the holder from the lamp base.
5. Release the lamp latch and turn down.
6. Remove the lamp from the holder.
7. Insert the new bulb so that the tab on the bulb holder fits into the recess in the reflector.
Stop lights, turn signals, reversing lights, rear fog light
1. Press the holder tab in the middle of the lamp unit to the side and remove the lamp unit.
2. Press the tabs of the holders on the right and left of the lamp unit towards each other and remove the lamp unit.
3. Press the release tab on the lamp unit and remove the lamp unit.
License plate light
1. Press the spring clip on one side and remove the bulb holder by pulling it down.
2. Press the tab on the opposite side and open the flashlight housing.
3. Remove the two screws on the back of the tailgate handle. Take out the flashlight.
Interior lamp (activated when the door is opened)
Reading lights (rear)
Visitor comments