Note. The calibration procedure for the transmission neutral position sensor is required after the following work has been completed:
- Replacing the transmission neutral sensor.
- Any repair work involving the removal of the transmission neutral sensor.
Prerequisites: Vehicle stationary, gear lever in neutral, clutch pedal not depressed.
1. Install the diagnostic tool.
2. Menu «The engine control unit» (Engine Control Module) select from list «Configuration/Reset Functions» (Configuration/Reset Functions), procedure «Neutral Position Sensor Learning» (Neutral Position Sensor Learn) and follow the instructions to complete the procedure.
3. After the calibration of the transmission neutral sensor is completed, the corresponding information will be displayed on the screen.
4. Turn off the ignition to complete the calibration of the transmission neutral sensor.
Visitor comments