The left stalk acts as a turn signal switch and a dipped/high beam switch.
Positions of the left stalk switch:
- 0a - direction indicators are off;
- 1a - the right turn indicator is on;
- 2a - the left turn indicator is on;
- 0b - outdoor lighting works regardless of the steering column switch (short-term non-fixed switching on of the main beam is possible 26);
- 1b - turning on the high beam of the headlights when the low beam is on;
- 2b - non-fixed inclusion of high beam headlights.
Depending on the equipment, the vehicle can be equipped with an automatic speed control system (Cruise control). In this case, additional control buttons are located on the left steering column switch.
Cruise control can only be activated at speeds over 30 km/h. Accelerate the car to the desired speed and press the I button, then take your foot off the gas pedal. The vehicle will maintain the set speed. To decrease or increase the set speed, press the R or I button for a long time or several times briefly, respectively, while the speed will decrease or increase in steps of 2 km / h. You can also increase the set speed if you accelerate the car with the gas pedal and release it (pressing the I button again is not required). To turn off the function, press the O button. Automatic shutdown occurs when the vehicle speed drops to 30 km / h, when the brake pedal is pressed, the clutch pedal is pressed (vehicles with manual transmission) or moving the selector to position N (vehicles with automatic transmission).
The right steering column switch controls the wipers and washers.
Right stalk position:
- 0a - windshield wipers and windshield washers are off;
- 1a - front washer is on (non-fixed position);
- 2a - the rear wiper is on (if installed);
- For - rear window washer and wiper included (if installed, non-fixed position);
- 0b - wiper and washer off;
- 16 - the intermittent mode of the front wiper is on;
- 26 - the first speed of the front wiper is on;
- 3b - the second speed of the front wiper is on.
Visitor comments